Lightning link chips12/17/2023 ![]() ![]() If the link would not move back far enough to pull the disconnector hook off the hammer, find out what's stopping it and correct the problem.Īssemble the parts. When you release the trigger, the link can no longer release the hammer from the cocked position. As long as you hold the trigger back, the link will release the hammer. keep holding the trigger, recock the hammer and do it all again. Now place a scribe or anything that will fit into the slot at the rear of the link and pull it toward the back of the receiver, the hammer should fall. It will be caught by the disconnector hook. ![]() Hold the trigger back and cock the hammer. To check the link for fit and function, drop it over the hook on the disconnector, refer to drawings [A) and (B). 043 slot can not be any more than 2.120.įile cr grind the outside edges to shape until it fits into the lower receiver without touching the inner receiver wails. The distance between the front (squared end) of the. NOTE.Now's the time to square the end of the. Square the ends and finish the slot using a needle file.Ĭlean up the oblong hole and. Cut the slot out with the dremel tool and bonded cutoff wheel. 130 cut at this time.Ĭenter punch and drill a 1/32 inch hole at each end of the. 130 wide tail that extends out of the oblong you have already cut. Next center punch and drill a l/B inch hole so you can cut out the. With a dremel tool and bonded cutoff wheel cut out the material between the four holes you drilled. Next center punch and drill a l/B inch hole at each corner of the large oblong hole at one end. ![]() When building the Lightning Link without a milling machine I find the simpliest way is to cut the long piece to length and width. all that's really important is that it fits inside the receiver and can move back and forth about 1/16 inch. If it's to fit in an after market lower receiver it may be necessary to change the outside dimensions. The drawings show the shape and give the dimensions for a Lightning Link that fits in the Colttm AR-15. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |